Winix PlasmaWave WAC-9000S Operator's Manual download pdf (Page 11)

REMOTE CONTROL OPERATION

PREPARATION

• Press and slide the back cover of the

remote to remove.

• Insert batteries as shown.

• Close the back cover.

BATTERY USE

• The batteries for the remote control are

for initial use only. Change the batteries

when necessary.

• When replacing the batteries, replace

both at once with 2 new AA batteries.

• Incorrect battery usage may cause

battery uid leakage and/or damage.

• When not using the remote control for an

extended period of time, remove

the batteries.

• Avoid dropping or damaging the remote

control. Keep remote control away from

direct sunlight or heaters.

USING THE REMOTE CONTROL

Proper conditions

• Operate the remote control facing the

air cleaner.

• Operate within 20 feet of the air cleaner.

Poor conditions that may impair

operation

• Any location where there is inverter

lighting equipment or electronic

spontaneous lighting equipment.

• When objects or furniture are located

between remote and air cleaner.

• When air cleaner unit is located in

direct sunlight.

• In areas where uorescent lighting is

ickering due to worn out bulbs.

• POWER

Use the POWER button to turn the power

on and off. A short "beep" will sound

when you turn the unit on or off. Once

the unit is on, it will automatically switch

into Automatic operation. Turn the unit

to manual control by pressing one of the

FAN CONTROL buttons.

• TIMER

This button is used to set the timer. Press

the button repeatedly to set the unit to

run for 1, 4, or 8 hours, or to cancel. Each

time you press the button, it will advance

to the next pre-set amount of time. The

indicator light on the unit will show the

remaining amount of time. The unit will

stop operating when the set amount of

time runs out.

• FAN CONTROL

• UP

Use this button to switch from

Automatic operation and increase the

fan speed level.

• DOWN

Use this button to decrease the fan

speed level.

• TURBO

Use this button to switch from

Automatic operation and begin the

maximum amount of room cleaning

and air movement.

• AUTO SLEEP

Use the TIMER button to manually turn

the light sensor on or off. With the light

sensor on, the unit will automatically

operate in Sleep mode when the room

is dark. When the room is light, the unit

will revert to its previous settings. Sleep

mode provides the lowest, quietest fan

setting and a dimmed display panel.

• PLASMA ON/OFF

Use this button to turn the

PlasmaWave

TM

generator on or off.

10 11

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

Comments to this Manuals

No comments